: Orifice

Description

Orifice plates are widely used for flow measurement as they provide the simplest and the most economical means of flow detection. Orifice plates are available in the concentric type that the round opening (Bore) of the orifice plate is positioned concentrically with the center of the pipe and the opening edge (Bore edge) is available either in the concentric square edge type (Sharp, square edge type) or in the quadrant edge type (Round edge type). Orifice plates are also available in the eccentric type that the opening of the orifice is shifted from the center of the pipe. They also are available in the segmental type that the opening is a circular segment and the orifice is comparable to a partially opened gate valve.

Specification

Orifice bore type	Concentric square edged orifice Quadrant edged orifice Eccentric orifice Segmental orifice
Flow calculation standards	ISO 5167-1 and 2 2003 AGA-3 ASME MFC-3M and 14M JIS Z 8762 BS 1042
Flange ratings	JIS 10, 16, 20, 30, 40, and 63K ANSI class 150, 300, 600, 900, 1,500 and 2,500Lb
Pressure taps	Flange taps Corner taps 1D and ½D (Radius) taps Pipe taps (2½D and 8D)
Plate thickness	3, 6, 9 and 12 mm and Over
Plate material	Standard : 304SS and 316L SS Non-standard : Monel, Hastelloy C, Teflon and etc.
Drain and vent hole	Per ASME/ISA recommendations Not drilled for orifice bores smaller than 25.4 mm
Markings	Upstream side of tab handle stamped "Upstream" and with bore type and size, line size, tag number and flange rating
Special markings	Special marking may be furnished to meet special requirement

Download

타이틀

F100_Orifice plate

F100

Attached files

Orifice

타이틀

Attached files

공유하기